Boat Vent Cover

Tom Niemi

Moderator
Staff member
Messages
6,020
Location
Plainwell, Michigan
My brother is rebuilding an older ski boat for a friend of his and it has a vent cover for a storage area. The original cover had seen its better days so I was asked to replicate it and here it is. I used jarrah as it will weather well and I had it, used tite bond III. Taint much but it is woodworking:)
1 Orig.jpg2 Orig.jpg3 Clone.jpg4 Clone.jpg5 Clone.jpg6 Louvers.jpg7 Louvers.jpg
 
Thanks fellas, Jarrah works well Glenn can splinter easily and real heavy. The tenons are integral Charlie, I just rounded the square tenons to round with a chisel and final fit with sand paper:)
 
Top