- Messages
- 7,984
- Location
- falcon heights, minnesota
after i picked the wife up from the gym, she wanted to go with me to pop's to see what i was going to be up to in the shop. she wanted to know all the names of all the machines that i had, and what they did. on the agenda for today was making a smaller cutting board out of the odds and ends from the board for the fair. i showed her the sled setup, and how i was going to cut the parts. then i showed her the finer points of gluing and clamping. once the clamps were in place, we went for a walk around the nearby lake (nice evening for it too). when we got back, the glue was set up, and i showed her how to square up the board, and how to use the drum sander to flatten it out. tomorrow is finish sanding and oil. sorry, she wouldn't allow any pics.