Daniel Edney
Member
- Messages
- 4
Good morning-
I wasn't sure exactly where to post this. I'm planning on building a vent hood above my outdoor grill. The wall behind the grill is brick. I'm assuming I use pressure treated 2x4's for the framing. I have cypress for the outer shell of the hood.
As for securing it to the brick wall, would I use tapcon screws, or some sort of anchor screw? I was also thinking of supporting the weight of the hood by connecting it to the ceiling above w/ more 2x6's inside the attic.
Thanks in advance.
I can post pictures if needed.
I wasn't sure exactly where to post this. I'm planning on building a vent hood above my outdoor grill. The wall behind the grill is brick. I'm assuming I use pressure treated 2x4's for the framing. I have cypress for the outer shell of the hood.
As for securing it to the brick wall, would I use tapcon screws, or some sort of anchor screw? I was also thinking of supporting the weight of the hood by connecting it to the ceiling above w/ more 2x6's inside the attic.
Thanks in advance.
I can post pictures if needed.