Mike Turner
Member
- Messages
- 361
- Location
- Laurinburg NC
I have a Jet 1642. A while back I apparently had a small piece of trash etc or I put too pressure on my spindle blank and buggered up the inside of the drive a little....just a little..not bad. I cleaned it up but since then have been a little leery of using a Morse taper driven center... I do but am caution...blow out and use a greeny. Anyhow I am looking for some centers I can use in my G3.
I do have this Big spur one...wiorks good but wanting some smaller type.
http://www.landingcrafts.com/mm5/me...D&Product_Code=N52-3954&Category_Code=CENTERS
Does anyone know of any other? maybe smaller ones???
I do have this Big spur one...wiorks good but wanting some smaller type.
http://www.landingcrafts.com/mm5/me...D&Product_Code=N52-3954&Category_Code=CENTERS
Does anyone know of any other? maybe smaller ones???
Last edited: