Hi everyone
I am trying to build a small base for a fountain we have. I want the sides to angle up so the angle between the floor and the side is 65 degrees. I want the base to "flare" off the vertical so the sides are 85 degrees and I want to mitre the corners.
So how do I set my SCMS? I assume I rip the pieces with a 15 degree angle on my table saw so the top and bottom edges are parallel and then do the mitre cuts.
I did well in geometry in HS but that was a LONG time ago and I am not doing well cutting test pieces.
Thanks for the assistance.
Jay
I am trying to build a small base for a fountain we have. I want the sides to angle up so the angle between the floor and the side is 65 degrees. I want the base to "flare" off the vertical so the sides are 85 degrees and I want to mitre the corners.
So how do I set my SCMS? I assume I rip the pieces with a 15 degree angle on my table saw so the top and bottom edges are parallel and then do the mitre cuts.
I did well in geometry in HS but that was a LONG time ago and I am not doing well cutting test pieces.
Thanks for the assistance.
Jay