S
Steve Clardy
Guest
I installed a 1/4" blade on the impressive bandsaw yesterday.
I needed 1/4", so I could cut out some knee knockers for a kitchen island.
The upper/rear roller is adjusted as far forward as it will go, lacking 3/8" of making contact with the rear of the blade.
Lower guide is fine.
Seems the front blade guard is in the way.
I'm thinking of taking a cutoff saw and notching the blade guard.
Or am I missing something here
I needed to get these done, so I went ahead and eased into them [ 1 1/2" Oak blanks] and didn't have any problems.
I needed 1/4", so I could cut out some knee knockers for a kitchen island.
The upper/rear roller is adjusted as far forward as it will go, lacking 3/8" of making contact with the rear of the blade.
Lower guide is fine.
Seems the front blade guard is in the way.
I'm thinking of taking a cutoff saw and notching the blade guard.
Or am I missing something here
I needed to get these done, so I went ahead and eased into them [ 1 1/2" Oak blanks] and didn't have any problems.
Last edited: