Ninh Shepherd
Member
- Messages
- 73
- Location
- Northwest Georgia U.S
Hi guys I was looking at some T-tracks on rockler today and seen the price. Not terrible but still over priced for what I can make them for. I can make any of these on this page
http://www.rockler.com/search/go?w=t-track
But my questions is which one!!!?
I'm looking for one for my home made table saw as of right now I have just a mitered joint down both sides of the blade using my router which aren't very straight and they tend to pinch each other when using my sleds. so I figure I will widen them (how ever much needed) and make me an actual t track. But is one kind better than the other ? I don't want to make one then later down the road get a diff one and wish I had made the second one because it's way more accommodating. I can make it any width even if it's 3in wide and only put to slots in it that only take up 1/3 of the three inches. So my current a lot width is not a concern as I can correct it properly and then make the T-Track accordingly. But again any suggestions on what kind or style ?
Thanks Guys!
~Ninja~
Sent from my iPhone using Tapatalk
http://www.rockler.com/search/go?w=t-track
But my questions is which one!!!?
I'm looking for one for my home made table saw as of right now I have just a mitered joint down both sides of the blade using my router which aren't very straight and they tend to pinch each other when using my sleds. so I figure I will widen them (how ever much needed) and make me an actual t track. But is one kind better than the other ? I don't want to make one then later down the road get a diff one and wish I had made the second one because it's way more accommodating. I can make it any width even if it's 3in wide and only put to slots in it that only take up 1/3 of the three inches. So my current a lot width is not a concern as I can correct it properly and then make the T-Track accordingly. But again any suggestions on what kind or style ?
Thanks Guys!
~Ninja~
Sent from my iPhone using Tapatalk