Searching for a 1/4" in-cannel gouge

glenn bradley

Member
Messages
11,515
Location
SoCal
I know I might get more responses in the Neanderthal Haven but, hope to find some good info here as well. I am looking for a 1/4" in-cannel gouge. I do a lot of floating tenons and I cut the mortises by router. The smaller the mortise the more fussy the fit and I sometime want to open thing up just a bit. A 1/4" in-cannel gouge would make this much quicker than slicing a bit off the tenon or other methods I have tried. I can find them in the $75 - $150 range but, since I am not wholly convinced that my thinking is correct, I was hoping to test my theory with something cheaper. Maybe I am breaking my own rules as I usually advise against throwing money away on "temporary" tools ;-) Anyone know of any products I have not found?
 
Top