Bob Gibson
Member
- Messages
- 11,473
- Location
- Merrimack, New Hampshire
Last night I was sitting in my family room watching TV. My wife came in and looked very surprised to see me. She asked who was using a sander down in my shop
I went down to the shop to see my DeWalt ros DW26453 jammed up against my spindle sander and work bench running in circles
I had used it earlier in the day but had been down in the shop several times after I used it. It was not running.
The only thing I can figure out, besides very unhandy ghosts, is that the lousy,hard to use rocker switch dewalt puts on the sander was not fully in the off position and slipped back into run mode
Ya I know it should of been unplugged but sometimes I forget.
I went down to the shop to see my DeWalt ros DW26453 jammed up against my spindle sander and work bench running in circles
I had used it earlier in the day but had been down in the shop several times after I used it. It was not running.
The only thing I can figure out, besides very unhandy ghosts, is that the lousy,hard to use rocker switch dewalt puts on the sander was not fully in the off position and slipped back into run mode
Ya I know it should of been unplugged but sometimes I forget.