Stuart Ablett
Member
- Messages
- 15,917
- Location
- Tokyo Japan
I have a McNaughton Center Saver coring system, I don't get to use it much as I don't get a lot of larger blanks, but I noticed today that the "New" version has a modified turret set up.....
and I've seen some with a bar that adjusts up and down on the square piece of tubing on the back as well.
I have to old T-turret, and being the fabricator that I am, I'm wondering if I could or should make a new version....?
Also I found this new video, boy does Dale Bonetz do a great job of explaining how to really use this tool, the best I'v seen yet, I'm going to watch it a few more times!
Anyone else using this tool regular like?
Also my old turret does not have any insert steps for the two blade sizes I have, the mini and the standard, so I guess I have to set the turret height for each blade....??
and I've seen some with a bar that adjusts up and down on the square piece of tubing on the back as well.
I have to old T-turret, and being the fabricator that I am, I'm wondering if I could or should make a new version....?
Also I found this new video, boy does Dale Bonetz do a great job of explaining how to really use this tool, the best I'v seen yet, I'm going to watch it a few more times!
Anyone else using this tool regular like?
Also my old turret does not have any insert steps for the two blade sizes I have, the mini and the standard, so I guess I have to set the turret height for each blade....??