Roger Tulk
Member
- Messages
- 3,018
- Location
- St. Catharines, Ontario, Canada
I've just assembled the Freestyle Woodcarver to my angle grinder, which I have never used. Here are pictures of the assembly. If you have experience with this thing, I would appreciate your comments in case I have missed something.
This is the naked tool:
The lower bushing with the fibre washer from the kit. I needed the washer to remove some play in the cutter when assembled.
The cutter in place.
Nylon bushing that came with the kit. The assembly instructions were vague, but I couldn't tighten the blade without this, in this position.
The upper bushing in place and tight.
The whole shebang, with the auxiliary guard in place.
I am not sure if this looks quite right, or what angle I am supposed to use the cutter at. With the auxiliary guard in place, it pretty well has to be at 90º. I'm not going to test it today, so I will receive any advice with great attention and thanks.
This is the naked tool:
The lower bushing with the fibre washer from the kit. I needed the washer to remove some play in the cutter when assembled.
The cutter in place.
Nylon bushing that came with the kit. The assembly instructions were vague, but I couldn't tighten the blade without this, in this position.
The upper bushing in place and tight.
The whole shebang, with the auxiliary guard in place.
I am not sure if this looks quite right, or what angle I am supposed to use the cutter at. With the auxiliary guard in place, it pretty well has to be at 90º. I'm not going to test it today, so I will receive any advice with great attention and thanks.