Dan Gonzales
Member
- Messages
- 511
- Location
- Whittier, CA, USA
I was stripping line off some reels at my workench when this idea popped in my head.
I dug out a scrap of 2" long 1x6 pine cutoff from the trash bin. Split it into a few pieces with a claw hammer. Nailed a 6 penny finish nail in about an inch. Made a 3/16" hole in my lockset jig. Chucked and clamped to the drill press.
The neat part is the block will spin on the nail when it comes to the end of the line.
Cheers,
I dug out a scrap of 2" long 1x6 pine cutoff from the trash bin. Split it into a few pieces with a claw hammer. Nailed a 6 penny finish nail in about an inch. Made a 3/16" hole in my lockset jig. Chucked and clamped to the drill press.
The neat part is the block will spin on the nail when it comes to the end of the line.
Cheers,