Ninh Shepherd
Member
- Messages
- 73
- Location
- Northwest Georgia U.S
I've done as much searching as I can and have yet to find a visual answer.
I would like to know of it is possible to make a three sided joint a box joint or dovetail.!?
Like (side)+(side)+(top) and have that type of joint on all three sides where it meets at the corner.
This may be a dumb question. But I feel as if it's possible but I can't visually picture it in my head!!!
Thanks in advance
~Ninja~
I would like to know of it is possible to make a three sided joint a box joint or dovetail.!?
Like (side)+(side)+(top) and have that type of joint on all three sides where it meets at the corner.
This may be a dumb question. But I feel as if it's possible but I can't visually picture it in my head!!!
Thanks in advance
~Ninja~