Roy Millsaps
Member
- Messages
- 399
- Location
- St. Mary's, Georgia
Here is a small sample of some Table tops an Marquetry Pieces I have Done
Marquetry
Tab tops Marquetry style
Marquetry
Tab tops Marquetry style
Table tops an Marquetry Pieces
- Thread starter Roy Millsaps
- Start date
Scott R Smith
Member
- Messages
- 542
- Location
- Humid Gulf Coast
Very nice work Roy.
I have a question for you though.
When you make something intracate, such as the eagal inlay with the oval around it.
Are you using a dremal to carve a smooth flat base surface for the inaly to sit on?
I have a question for you though.
When you make something intracate, such as the eagal inlay with the oval around it.
Are you using a dremal to carve a smooth flat base surface for the inaly to sit on?
Roy Millsaps
Member
- Messages
- 399
- Location
- St. Mary's, Georgia
I use a dermal at about 50 thousands of an inch deep 1/32 down spiral bit
Scott R Smith
Member
- Messages
- 542
- Location
- Humid Gulf Coast
Thanks 