Carol Reed
In Memoriam
- Messages
- 5,533
- Location
- Coolidge, AZ
The plan is to marry the iBox jig to a bench top saw. Because I have the saw available and I don't have a better tablesaw available, and because I have a zillion boxes to make. And now that I have seen Glenn's sled support, hmmmm....
The saw is a Rockwell benchtop belt drive. It needs a little sprucing up.
So far:
Ready for surgery:
What kind of lube should I use between the cast aluminum and the steel in two spots?
This little critter is a small belt drive. But it runs well.
The saw is a Rockwell benchtop belt drive. It needs a little sprucing up.
So far:
Ready for surgery:
What kind of lube should I use between the cast aluminum and the steel in two spots?
This little critter is a small belt drive. But it runs well.
Last edited: