Rob Keeble
Member
- Messages
- 12,633
- Location
- GTA Ontario Canada
Well even though some of his points are valid and i dont have a dp fence table yet, i cannot agree with him on not having one.
Its all good and well with his dp motor and what he is doing but get something way bigger, put a 2 inch hole saw in it and try cutting 2 inch circles out of 3/4 ply not holding the scrap securely. I ended up using a circle jig and did them on my bandsaw.
Also the run out he is witnessing is in my experience a function of the cheapo small dp and poor chuck quality and drill.
But hey each to their own way as Glenn says. I just prefer to be safe when a cutting edge is involved.
Sent from my SGH-I337M using Tapatalk
Its all good and well with his dp motor and what he is doing but get something way bigger, put a 2 inch hole saw in it and try cutting 2 inch circles out of 3/4 ply not holding the scrap securely. I ended up using a circle jig and did them on my bandsaw.
Also the run out he is witnessing is in my experience a function of the cheapo small dp and poor chuck quality and drill.
But hey each to their own way as Glenn says. I just prefer to be safe when a cutting edge is involved.
Sent from my SGH-I337M using Tapatalk