Roy Millsaps
Member
- Messages
- 399
- Location
- St. Mary's, Georgia
Well I got tired of having to go between 2 areas to carve or find the right carving tool so I built a nice one here is what I had before
Now here is what I got now, since I got banned last week to the shop due to making the girls mad at me I started to make the new bench an did some veneer panels out of cherry. This new bench is just a prototype from rejected wood I have the real one is going to be nicer but want to find out what is good an bad with this one first
Now its been done I hoping to drill the holes tomorrow was going to hold off until I have the tail vice but its hard to find a small one so I will use bench dogs that I can make here in the shop. The top tilts up all the way from 15 to 45%
I also going to make a few accessories for the bench like a cabinet for the bottom area an making a separate cabinet for all my hand carving tools
Do you think I missed anything ???
Now here is what I got now, since I got banned last week to the shop due to making the girls mad at me I started to make the new bench an did some veneer panels out of cherry. This new bench is just a prototype from rejected wood I have the real one is going to be nicer but want to find out what is good an bad with this one first
Now its been done I hoping to drill the holes tomorrow was going to hold off until I have the tail vice but its hard to find a small one so I will use bench dogs that I can make here in the shop. The top tilts up all the way from 15 to 45%
I also going to make a few accessories for the bench like a cabinet for the bottom area an making a separate cabinet for all my hand carving tools
Do you think I missed anything ???