- Messages
- 7,995
- Location
- falcon heights, minnesota
started the plaque for pop for fathers day yesterday morning. seemed to be going ok. it had generated 447k lines of code, and was cutting rather smoothly, when i left it had gone through over 115k of the code. then i had to go to a fathers day to-do at the wife's church was putting on. when we got back about 6 hours later, it was still going, but instead of the smooth moves it was doing, it was moving in fits and starts, from a little over 1/8 to 1/2 inch. it was following the path it was supposed to, but real herky-jerky like that. i'll be putting in a call with the shapeoko people today, any ideas here? almost forgot, when we got back it had roughly 206k of code to go before finishing.