Toni Ciuraneta
Member
- Messages
- 5,629
- Location
- Catalunya
¾" here Jim.
Would it be so critical 1mm difference? if a 20mm dog hole was used? 3/4" = 19.05mm unless you already got the bench dogs.
¾" here Jim.
Would it be so critical 1mm difference? if a 20mm dog hole was used? 3/4" = 19.05mm unless you already got the bench dogs.
Will a 3/4 hold fast, bench dog etc. work with 20mm holes? Just curious.
Holdfast? Dunno.
Bench dogs? No! They'll fall right through, unless they have a collar at the top. Even so, they'd be a loose fit, for sure.
If you were going to build a bench Jim would you go with 3/4 or 20mm?
Looks nice!
What was the plan for the drop front on the non vise side? I think you might have explained it at one point but I'm not seeing it...