car cribbage board fabrication

Dan Noren

Moderator
Staff member
Messages
7,984
Location
falcon heights, minnesota
i thought it might be fun for others to see the magic of the cnc while creating the 57 chevy sport coupe. this go round i started off with drilling the holes (i forgot to change the drilling from pecking, and it took a while longer), then i went on to engraving the title at the top, the skunk lines with a nice letter s, then a look at the tool path display that shows where cutting is being done, the start of engraving the car body details, and the finished board. all in all, with the pecking of the holes, it took about an hour and a half to make this board.
 

Attachments

  • 001 drilling holes.jpg
    001 drilling holes.jpg
    72.8 KB · Views: 11
  • 002 carving name.jpg
    002 carving name.jpg
    58.5 KB · Views: 12
  • 003 name carved.jpg
    003 name carved.jpg
    58.9 KB · Views: 13
  • 004 skunk lines engraved.jpg
    004 skunk lines engraved.jpg
    72.3 KB · Views: 14
  • 005 first skunk line.jpg
    005 first skunk line.jpg
    63.9 KB · Views: 13
  • 006 second skunk line.jpg
    006 second skunk line.jpg
    69.5 KB · Views: 13
  • 007 tool path display.jpg
    007 tool path display.jpg
    48.9 KB · Views: 12
  • 008 start of car body engraving.jpg
    008 start of car body engraving.jpg
    73.1 KB · Views: 13
  • 009 car body engraved.jpg
    009 car body engraved.jpg
    82.8 KB · Views: 14
  • 010 tail fin detail.jpg
    010 tail fin detail.jpg
    79.4 KB · Views: 14
Top