My XYZ For the Swap
Well, I dug into my scrap buckets and found some suitable scrap to get me started,So here goes.
Pulled out some walnut pieces and started cutting them down. Then as luck would have it the table saw crapped out for some strange reason.
After troubleshooting the motor There was no problem there, so I went to the switch and Yep, It was toast inside , good old Chiwaneese products. So I wired around the switch and got the old beast going again. Needless to say I wasn't in the mood for much more today so tomorrow I will give it another go..
I'm supposed to respect my elders, but its getting harder and harder for me to find one now.