Roger Pozzi
Member
- Messages
- 75
- Location
- Mount Vernon, Ohio
I didn't know where to post this so, it's here unless the mods want to move it.
My shop is a 10X16 wooden shed and I'm lucky enough to have electricity in it. I'm basically limited to propane heat right now and have been using a Big Buddy heater with success. But, with the heat comes too much humidity causing rust on all cast surfaces and steel tools in drawers. I guess that cancels the previous statement about success.
My question is, has anyone else had to deal with this problem? Will a small (how small) dehumidifier help?
I have a very limited budget so I'm looking for relatively inexpensive solutions, if those exist. What the local professionals (?) suggest would take me over a year to pay for, so there would be no need for the shop by then.
Thank you in advance for any and all expertise shared here.
My shop is a 10X16 wooden shed and I'm lucky enough to have electricity in it. I'm basically limited to propane heat right now and have been using a Big Buddy heater with success. But, with the heat comes too much humidity causing rust on all cast surfaces and steel tools in drawers. I guess that cancels the previous statement about success.
My question is, has anyone else had to deal with this problem? Will a small (how small) dehumidifier help?
I have a very limited budget so I'm looking for relatively inexpensive solutions, if those exist. What the local professionals (?) suggest would take me over a year to pay for, so there would be no need for the shop by then.
Thank you in advance for any and all expertise shared here.