Rob Keeble
Member
- Messages
- 12,633
- Location
- GTA Ontario Canada
I put this here mainly because i wanted to make sure to get attention of those who have had experience with veneer.
For those of you that have done veneering, and cut veneer , my question is do you think that a drag knife on a cnc could cut out shapes on veneer?
In the event that you are not aware of what a drag knife is here is a video of it cutting leather on a cnc table.
https://www.youtube.com/watch?v=bMoRUZnvbXw
My thoughts were leather is altogether a different material and knives cut it normally. I am wondering if it would do veneer ?
Would love some opinions or experience on this.
I realise you could cut the veneer with a bit by routing out the part you want, i am specifically wondering if the drag knife type of setup would do it.
For those of you that have done veneering, and cut veneer , my question is do you think that a drag knife on a cnc could cut out shapes on veneer?
In the event that you are not aware of what a drag knife is here is a video of it cutting leather on a cnc table.
https://www.youtube.com/watch?v=bMoRUZnvbXw
My thoughts were leather is altogether a different material and knives cut it normally. I am wondering if it would do veneer ?
Would love some opinions or experience on this.
I realise you could cut the veneer with a bit by routing out the part you want, i am specifically wondering if the drag knife type of setup would do it.