Jeff Horton
Member
- Messages
- 4,272
- Location
- The Heart of Dixie
OK you know the drill.
Bench shots and what your working on this weekend. Lets show/discuss them here.
Since I have hit a layover on the jointer I have am going to jump into the bandsaw. It looks to be a very straightforward project. Except for the motor setup (just like the jointer) I don't expect any problems. I stripped it down last night to the bare casting. It's been primed and painted a few years ago. I have to strip some places down but over all it's not bad. So that it the project for today.
I am hosting an Old Arn mini conference today. 2 old arn guys are coming by the shop.
Jeff wants to clean up a drill press column on my lathe. He is bringing me two motors, one is probably going on the jointer.
Then Bruce is coming down from Tennessee and is an expert on Rotary Phase Converters is going to educate me on building one of these. I think he is bringing one for Show and Tell. Will be picking his brain on how to build one of these.
Sunday is Church and will probably piddle around in the shop that afternoon.
Jeff
Bench shots and what your working on this weekend. Lets show/discuss them here.
Since I have hit a layover on the jointer I have am going to jump into the bandsaw. It looks to be a very straightforward project. Except for the motor setup (just like the jointer) I don't expect any problems. I stripped it down last night to the bare casting. It's been primed and painted a few years ago. I have to strip some places down but over all it's not bad. So that it the project for today.
I am hosting an Old Arn mini conference today. 2 old arn guys are coming by the shop.
Jeff wants to clean up a drill press column on my lathe. He is bringing me two motors, one is probably going on the jointer.
Then Bruce is coming down from Tennessee and is an expert on Rotary Phase Converters is going to educate me on building one of these. I think he is bringing one for Show and Tell. Will be picking his brain on how to build one of these.
Sunday is Church and will probably piddle around in the shop that afternoon.
Jeff