Leo Voisine
Member
- Messages
- 5,732
- Location
- East Freeetown, Massachusetts
I made this today.
It is functional, but not pretty yet.
I will make it pretty after I get the machine settings set up via using this device.
Ohhh - it is a tram to help me get the spindle perpendicular to the machine bed. I am going to shoot to be within .001 over 12" Right now, it is not even reasonably acceptable.
It could be used on a drill press also.
It is functional, but not pretty yet.
I will make it pretty after I get the machine settings set up via using this device.
Ohhh - it is a tram to help me get the spindle perpendicular to the machine bed. I am going to shoot to be within .001 over 12" Right now, it is not even reasonably acceptable.
It could be used on a drill press also.
Last edited: