Rob Keeble
Member
- Messages
- 12,633
- Location
- GTA Ontario Canada
Whats your thoughts on the shapeoko 3 with the dewalt router used for spindle
I am on the edge since i seen some videos of it with the Dewalt router cutting aluminum.
If i get in the water i am looking at the XXL unit to get the largest cutting area which just makes it for a project i have in mind.
Now i see the difference between the standard unit and the xxl upgrade kit versus the xxl unit on it own is only $100. Looks pretty attractive to order it in that form .
Any thoughts and opinions welcome.
The rails i see on the shapeoko 3 look nice and beefy in comparison to the XCarve.
I am on the edge since i seen some videos of it with the Dewalt router cutting aluminum.
If i get in the water i am looking at the XXL unit to get the largest cutting area which just makes it for a project i have in mind.
Now i see the difference between the standard unit and the xxl upgrade kit versus the xxl unit on it own is only $100. Looks pretty attractive to order it in that form .
Any thoughts and opinions welcome.
The rails i see on the shapeoko 3 look nice and beefy in comparison to the XCarve.