Tom Baugues
Member
- Messages
- 2,794
- Location
- Lafayette, Indiana
Finally got started on our kitchen shiplap style panels today. I'm using 1/4" subflooring panels. Didn't have a real good way to cut the panels but I ended up clamping a 2x4 underneath for support and then a straight board on top to guide my jig saw. Cuts turned out ok but this material is simply not made for this purpose and was a challenge to end up with real smooth edges. Took a few measurements and then got busy nailing the panels to the walls today with my brand new brad nail gun and brand new air compressor.
I think the end result will be what my wife is looking for but if I were to do it all over again....I would use a better material than this subflooring. It's ok and will get the results we're looking for but it will require a bit more work to make it that way.
I have a few more to put of these walls tomorrow then I will also be doing the space above the kitchen cabinets as well. The panels will then be painted.
I think the end result will be what my wife is looking for but if I were to do it all over again....I would use a better material than this subflooring. It's ok and will get the results we're looking for but it will require a bit more work to make it that way.
I have a few more to put of these walls tomorrow then I will also be doing the space above the kitchen cabinets as well. The panels will then be painted.