Leo Voisine
Member
- Messages
- 5,728
- Location
- East Freeetown, Massachusetts
To me, I do NOT see this as a violation in woodworking.
I see this differently.
1) The complexity of the shape
2) The complexity of the 5 axis machine
3) The motions of the axis's
4) The table lift in the end segments
5) The skills in programming
6) The fixturing
7) The operating and setup of the machine
8) The cutter design
9) The accuracy is the piece being made
10) And of course the wood
I see this differently.
1) The complexity of the shape
2) The complexity of the 5 axis machine
3) The motions of the axis's
4) The table lift in the end segments
5) The skills in programming
6) The fixturing
7) The operating and setup of the machine
8) The cutter design
9) The accuracy is the piece being made
10) And of course the wood