glenn bradley
Member
- Messages
- 11,557
- Location
- SoCal
I will usually make something rather than buy it. Especially something like this but, the new DP was lonely. It's not that I'm cheap, I just need all the experience I can get and building jigs and shop cabinets is as good a way as any to rack some up. Seriously, it was on sale and with an email coupon it wasn't much more than the parts to build. I apologize to the jig-gods.
The instructions direct you to use the supplied sheet metal screws and fender washers to attach it to the existing DP table . Being the way I am, I'll probably go for four 3/8" threaded inserts threaded in and epoxied with bolts and washers from underneath.
I'll post more shots once installed.
The instructions direct you to use the supplied sheet metal screws and fender washers to attach it to the existing DP table . Being the way I am, I'll probably go for four 3/8" threaded inserts threaded in and epoxied with bolts and washers from underneath.
I'll post more shots once installed.