- Messages
- 20,157
- Location
- Springfield, Missouri
I started this last night on the 3d printer with glow in the dark filament.
http://www.thingiverse.com/thing:1045054
https://www.youtube.com/watch?v=bsfeLInPl6o
It was in 4 pieces, took about 9 hours to complete.
After it came off the printer, the printer prints a brim around the object to help hold it in place as an insurance policy
I assembled the 4 pieces using Loctite Ultra Gel superglue, which was recommended for PLA.
Glows very well once held up to a light for a few seconds...
http://www.thingiverse.com/thing:1045054
https://www.youtube.com/watch?v=bsfeLInPl6o
It was in 4 pieces, took about 9 hours to complete.
After it came off the printer, the printer prints a brim around the object to help hold it in place as an insurance policy
I assembled the 4 pieces using Loctite Ultra Gel superglue, which was recommended for PLA.
Glows very well once held up to a light for a few seconds...