While I was without Internet yesterday, I built a torsion box to mount my printer on. I took it out of the clamps and set the printer on it this morning. After making a few measurements, I found a couple of discrepancies that I knew were right when I completed assembling the printer a few days ago. The bottom line is I found the bench where I assembled the printer was a little out of flat. On the torsion box, I re-aligned the printer, adjusted the table to the nozzle. In the process, I found the positions of the left and right Z axis lead screws had shifted; nothing appears to be binding, so I don't know what happened there unless the motors skipped for some reason.
I downloaded and installed Repetier - free version. I can control the axes and it reads the end and bed temps. When I attempt to load a gcode file to run from Repetier, I get a window that says I need PRO. So, I started the "Box" file from the LCD menu to see what happens. ...Film at 11...