Stuart Ablett
Member
- Messages
- 15,917
- Location
- Tokyo Japan
The faces on my SawStop tablesaw are getting a bit rough.
When not in use my fence stands on one end against my lathe, sometimes I put is down less than gently
The end that hits the ground has become dented, it got kind of mushroomed over, not good.
Replacing these faces would be a bit of work.
I look at the replaceable fence on my Incra tools and think "That looks a lot easier".
I found this online, and thought, "That looks good".
After some looking around I found this locally, it is about double the height of the fence now, so I figure I'll cut it in half and mount half on each side of the fence with the one T-track on the top.
Should work?
Then I'll be able to easily make new fence faces for it even tall fences etc.
Should work....?
Cheers!
When not in use my fence stands on one end against my lathe, sometimes I put is down less than gently
The end that hits the ground has become dented, it got kind of mushroomed over, not good.
Replacing these faces would be a bit of work.
I look at the replaceable fence on my Incra tools and think "That looks a lot easier".
I found this online, and thought, "That looks good".
After some looking around I found this locally, it is about double the height of the fence now, so I figure I'll cut it in half and mount half on each side of the fence with the one T-track on the top.
Should work?
Then I'll be able to easily make new fence faces for it even tall fences etc.
Should work....?
Cheers!