- Messages
- 8,631
- Location
- Thomasville, GA
Actually a CNC project to support my 3D printer operation. The filament reel stand that came with the printer was made to fit an 8mm all thread with nuts on each end. I found and printed a new hub system, then sized down an end nut assembly to suit me. Then, I needed something better to hold all that.
Drew this up in VCarve, cut it on my SO2 CNC.
At least it's woodworking of a sort!
Drew this up in VCarve, cut it on my SO2 CNC.
At least it's woodworking of a sort!