Problem Push/Pulling A Rail

Jeff Wright

Member
Messages
92
Location
Treasure Island FL
In the attached photo of a rail I created, I am having trouble changing the length of the rail. Looking at the end, you'll see that the rail appears to be comprised of many smaller parts. When I try to push or pull to change the length, each area needs to be altered and some of those areas won't move. How can I make a rail with a profile edge such as this ogee where the end of the rail appears as one continuous surface and will react to the push/pull tool appropriately? Any help is appreciated. Note: The actual SU file is too large to post. I could email it to you.
 

Attachments

  • rail.JPG
    rail.JPG
    45 KB · Views: 20
Push/Pull is the wrong tool, Jeff. Use the Move tool instead. Look at the video clip. Sorry, this one is silent. The important thing is to use a left to right selection box around the geometry you want to move.
 
Top