- Messages
- 8,633
- Location
- Thomasville, GA
For those with an Anet A8 3d printer, what is your EEPROM setting for Extruder Steps/mm?
I'm on Skynet3D-V2.3.2 and have been getting underextrusion. After trying to adjust for it in S3D and not having great success, I tried calibrating the steps by marking the filament and extruding a 100mm length. I think I'm getting somewhere but I'd like to know what your setting for that value is.
Thanks!
I'm on Skynet3D-V2.3.2 and have been getting underextrusion. After trying to adjust for it in S3D and not having great success, I tried calibrating the steps by marking the filament and extruding a 100mm length. I think I'm getting somewhere but I'd like to know what your setting for that value is.
Thanks!