Pads for cutting boards.

Mike Tate

Member
Messages
13
Location
Shannon, MS
I have made several end grain cutting boards for my contribution to an upcoming church bazaar. I didn't anticipate any problem locating pads for them. I found stainless screws at Home Depot, but only four 4 pks of the pads. What topic should look up on line? I am needing about 80 pads. Thanks for any help.
 
I agree with Allan use the white feet with stainless screws. That is if I use them at all. Usually let the board lay flat. Finger notches on end will help in picking board up.
David
 
Top