- Messages
- 11,635
- Location
- Constantine, MI
Well, a day's work down the tubes. I am attempting to make a miter sled based on the design by Stumpy Nubs. Sound design, good instructions, versatile jig. Unfortunately, after getting it all together to the point it is ready for testing I noticed it was not lying flat on the table saw. Some not so socially acceptable terms uttered under my breath.
I ran a couple of test cuts and the miter is dead on, but the face of the miter is not, as I suspected, 90* to the sides. What a pain. No way to correct it as far as I can see so I guess I'll start all over again tomorrow.
I ran a couple of test cuts and the miter is dead on, but the face of the miter is not, as I suspected, 90* to the sides. What a pain. No way to correct it as far as I can see so I guess I'll start all over again tomorrow.