Sean Wright
Member
- Messages
- 902
- Location
- WNY, Buffalo Area
I just made a few Zero Clearance Inserts for my table saw. I have only made rip and cross cuts with them in. I was thinking about making some from my CMS.
Does anyone use ZCI when making bevel cuts on a table saw or on a CMS...or for that matter compound miter cuts? Is it better to put the wider factory insert back in for these cuts?
I have a dado insert for my table saw, its a one size opening for no matter what size dado you are making. Should I keep using that, or should I make up a stack of ZCIs? (one for each size dado)
Thanks !
Does anyone use ZCI when making bevel cuts on a table saw or on a CMS...or for that matter compound miter cuts? Is it better to put the wider factory insert back in for these cuts?
I have a dado insert for my table saw, its a one size opening for no matter what size dado you are making. Should I keep using that, or should I make up a stack of ZCIs? (one for each size dado)
Thanks !