Toni Ciuraneta
Member
- Messages
- 5,629
- Location
- Catalunya
Being on the way of setting up my new workshop, I'm giving it a tought about setting up some sort of dust extraction with a cyclone.
I've looked at Bill Pentz cyclone page, and some others but I'm quite puzzled because everything ends up needing at least 5 hp and 1000cfm if I want to have good fine dust extraction, and this ends with needing a 3 phase outlet.
Has any of you other experience than this, I've seen Frank's Pellow workshop set up using an Oneida cyclone but I think that is 3 phase as well, and I'd like to know how good is it at picking up fine dust not only wood chips.
Any suggestion will be welcome.
BTW I have a single phase 220V 50hz power source.
I've looked at Bill Pentz cyclone page, and some others but I'm quite puzzled because everything ends up needing at least 5 hp and 1000cfm if I want to have good fine dust extraction, and this ends with needing a 3 phase outlet.
Has any of you other experience than this, I've seen Frank's Pellow workshop set up using an Oneida cyclone but I think that is 3 phase as well, and I'd like to know how good is it at picking up fine dust not only wood chips.
Any suggestion will be welcome.
BTW I have a single phase 220V 50hz power source.