Mike Gabbay
Member
- Messages
- 180
- Location
- Herndon VA
Ok it may be time to buy a DT jig. Two reasons I think it's time.... I've been slowly (dead snail pace ) working on my bench that has a 2 1/4" x 5" front and side apron. I was cutting halfblind DTs for the front and sides. The problem is my halfblinds on this size of material is not that great. It seems that the overall stock thickness magnifies any issues with fit.
The second reason is I looking at building kitchen cabinets in the Fall.
That being said, I'm looking for recommendations. Ideally it would be nice to get a DT jig that can handle larger thickness stock and can also handle halfblinds as well as adjustable tails like with the Leigh jigs.
Thanks, Mike
The second reason is I looking at building kitchen cabinets in the Fall.
That being said, I'm looking for recommendations. Ideally it would be nice to get a DT jig that can handle larger thickness stock and can also handle halfblinds as well as adjustable tails like with the Leigh jigs.
Thanks, Mike