Bob Wiggins
Former Member (by the member's request)
- Messages
- 125
- Location
- 140 miles west of tulsa
1) Is there a specific name for this type of carving on the back?
2) As can bee seen in the pic it needs a new arm. The way I see it steam bending would be the only correct way to make a replacement arm. Would that be too difficult, for a first bending project, for a person with say maybe average woodworking skills if he does some research first? thanks
2) As can bee seen in the pic it needs a new arm. The way I see it steam bending would be the only correct way to make a replacement arm. Would that be too difficult, for a first bending project, for a person with say maybe average woodworking skills if he does some research first? thanks