Al killian
Member
- Messages
- 1,940
- Location
- Floydada, Tx
As part of fixing up the MIL resturaunt I made a new railing out of very rough 2x4's. I had to glue some up to make the two new post that where needed. My RAS could not cut all the way thru the post which where around 3-1/2" square. I had to you a hand saw to finish the cut. The post had to be cut a angle to match the stairs. They are done now, but wondering how others might have done it.How would you cut them if you had your choice a RAS,circlar saw or a hack saw? Currently I only have one ww saw and that is a little gent saw for trim and stuff. Hopefully I can get my bs wheel replaced and working soon. It sucks being a newbie to ww when makeing anything other then square things.