Aaron Beaver
Member
- Messages
- 427
- Location
- Missouri
How would you go about measuring to make sure the outsides are 2 1/4 when done? If I make my piece over size to say 3" I can make the first cut and not worry to much about it, just have to make sure I take enough off to make a sharp corner.
Only way I can think of is to measure and mark 2 1/4 and sneak up on the line, is there a better way? Saw is a left tilt fyi.
Thanks
Only way I can think of is to measure and mark 2 1/4 and sneak up on the line, is there a better way? Saw is a left tilt fyi.
Thanks