Tempering Oven Build -WIP

="http://familywoodworking.org/forums/showthread.php?p=51159#post51159"]Lacer-esque Skew

Won't be long Alex and I can send you these blanks, hardened on one end, and still annealed on the other.

Cheers!

Very nice chisel Stu. I will try and make one similar. Many, many thanks for all the hard work you are doing. I am correct thinking the annealed end will go into the chisel handle? Are you leaving this end annealed so it is easier to work into a taper on the grinder?
 
Last edited:
That is correct Alex, also, in the event of a HUGE catch, the idea is it would have some give to it, and NOT snap off, if the whole piece of steel was hardened it "Could" snap off.

Cheers!
 
OK, I got one of the scrapers done..........

big_scraper.JPG
Well, there it is!

Yep, it's a monster! :D

Here it is compared against a 1/2" Hamlet bowl gouge......

big_scraper_comaro.JPG

I've not had a chance to use it yet, but I'm sure it will work fine!
 
Top