Bart Leetch
Member
- Messages
- 3,206
I have both a shaper with a 1/2" arbor & a shaper with a 1" arbor.
I see shaper cutters with a 3/4" arbor hole is it possible to use a sleeve to increase the 1/2" arbor up to 3/4" to use a cutter with a 3/4" arbor hole?
Is this cutter made to be used so that it can be used to round over either a 1/4" or 1/2" edge & how would it be used. As I was looking at it it only turns one way so it can't be turned over. Would it be used under for one size & over for the other size?
http://www.grizzly.com/products/C2004
Is there a good place to buy at a reasonable cost both 1/2" arbored cutters for most of my hobby wood working as well as 1" arbored cutters when necessary.
Thanks
I see shaper cutters with a 3/4" arbor hole is it possible to use a sleeve to increase the 1/2" arbor up to 3/4" to use a cutter with a 3/4" arbor hole?
Is this cutter made to be used so that it can be used to round over either a 1/4" or 1/2" edge & how would it be used. As I was looking at it it only turns one way so it can't be turned over. Would it be used under for one size & over for the other size?
http://www.grizzly.com/products/C2004
Is there a good place to buy at a reasonable cost both 1/2" arbored cutters for most of my hobby wood working as well as 1" arbored cutters when necessary.
Thanks
Last edited: