Jeff Horton
Member
- Messages
- 4,272
- Location
- The Heart of Dixie
Need to make some molding for the wine cabinet. I don't have anything in my shaper tooling that I like for this. I was thinking of starting with a crown cut on the Table saw then going from there and doing something additional on the shaper.
I have seen this done on the table saw. I have never done it but doesn't look hard. Then I got to thinking why couldn't I do that on the RAS? Just turn the arm to 30 degrees instead of setting up fence(s) on the table saw.
I have seen this done on the table saw. I have never done it but doesn't look hard. Then I got to thinking why couldn't I do that on the RAS? Just turn the arm to 30 degrees instead of setting up fence(s) on the table saw.