Gerry Maul
Member
- Messages
- 19
- Location
- dunsmuir ca
just picked up a 45 degree lock joint bit, pretty formadable looking. anybody have any luck with them ? any do's or don'ts? thanks Thanks Gerry
Charlie,
I'm sure your are correct because 1 - 3 make so much sense, but I am not visualizing # 4.
Thanks...
Charlie,
I'm sure your are correct because 1 - 3 make so much sense, but I am not visualizing # 4.
Thanks...
This is so frustrating! Here's the key phrase:
"These joints can not be cut free hand."
And I'm told the same goes for molding. No matter how hard I try by hand, the slight variations in pressure, etc., lead to less than a perfect fit. So what I need is a power feeder. Yeah, ok. That makes sense. So how much is a power feeder? Well, this one's 300:
Bill
I have been considering getting one of these bits for a while now. Seeing it in practice from the link that Glenn posted, has me sold.
I do have a question, I know that the standard mitre lock bits are usually made for 3/4in thick stock. Does anyone make one for thinner stock, like 1/2in?
Thanks !