Mark Kosmowski
Member
- Messages
- 1,456
- Location
- Central (upstate) NY
Could I get some ideas on how to cut tapers?
I'm currently thinking that this will be the excuse I need to make some circ. saw guides, but am interested in hearing how you folks do this.
The pieces I'll working with will be about 20" long, going from about 4" at low end to 12 - 18" at wide end. I'll be needing to make glue-up panels for these pieces.
I'm currently thinking that this will be the excuse I need to make some circ. saw guides, but am interested in hearing how you folks do this.
The pieces I'll working with will be about 20" long, going from about 4" at low end to 12 - 18" at wide end. I'll be needing to make glue-up panels for these pieces.