Stuart Ablett
Member
- Messages
- 15,917
- Location
- Tokyo Japan
.......... "Dungeon" made too
I know not much, but it only took me about 15 minutes to make it, I had the 1" rod stock cut to length, and I just drilled a hole in it, tapped it, then I drilled and counter sunk a hole in the bar stock, and put the two together, I tried it out and it works fine, one thing I will do, is polish it up a bit, too many ragged edges on it.
Here is one that sells for $48.........
OK, mine does not have the gusset underneath it, but I can use mine on a smaller box
Cheers!
I know not much, but it only took me about 15 minutes to make it, I had the 1" rod stock cut to length, and I just drilled a hole in it, tapped it, then I drilled and counter sunk a hole in the bar stock, and put the two together, I tried it out and it works fine, one thing I will do, is polish it up a bit, too many ragged edges on it.
Here is one that sells for $48.........
OK, mine does not have the gusset underneath it, but I can use mine on a smaller box
Cheers!