Results 1 to 4 of 4

Thread: HF bar clamps - half price

  1. #1
    Join Date
    Apr 2007
    Location
    No, not all of SoCal is Los Angeles!
    Posts
    9,076

    HF bar clamps - half price

    In the most recent flyer. You have to pick through them to watch for crooked faces but at $2 for a 6" this is a good way to pick up a few spares.
    Any sufficiently advanced technology is indistinguishable from magic.
    - Arthur C. Clarke

  2. #2
    Join Date
    Dec 2006
    Location
    Oregon
    Posts
    65
    http://www.harborfreight.com/ bottom of page
    Bob
    Last edited by Robert E Lee; 11-23-2007 at 04:14 AM.

  3. #3
    Join Date
    Feb 2007
    Location
    Milford, PA
    Posts
    20
    DON'T buy them.
    I have 4 and they just won't stay tight.

    However, if you need spreaders for just a little bit of pressure, they seem to work just OK.
    Carry on, regardless.

  4. #4
    Join Date
    Apr 2007
    Location
    No, not all of SoCal is Los Angeles!
    Posts
    9,076
    Bob is right. The "Grip-Tite" knock-offs are pretty poor. I was referring to the clutch style bar clamps. Take care here as well as some of the castings are no where near square on the face. Its the typical HF diamond in the rough search.

    I assume everyone probably picked up the Irwin deal at Lowes and elsewhere; 4, 6" Grip-Tites for $20. I think Irwin has these priced high at the normal price but, for $5 each these guys come in handy.
    Any sufficiently advanced technology is indistinguishable from magic.
    - Arthur C. Clarke

Similar Threads

  1. Peachtree Half Price on 8" Stack Dado Set
    By Dan Mooney in forum Hot Deals
    Replies: 0
    Last Post: 01-14-2012, 03:45 PM
  2. half flat and half round
    By larry merlau in forum General Woodworking Q&A
    Replies: 27
    Last Post: 12-06-2008, 11:55 PM
  3. Freud LU85R010 (10" x 80T) at Sears - Half Price
    By glenn bradley in forum Hot Deals
    Replies: 19
    Last Post: 11-04-2008, 08:45 PM
  4. P-Tree half price Sale on DC elbows, gates, and all that
    By glenn bradley in forum Hot Deals
    Replies: 0
    Last Post: 08-22-2008, 03:06 PM
  5. Half Price Sale
    By Vaughn McMillan in forum Lathe Project Showcase
    Replies: 21
    Last Post: 08-09-2008, 10:40 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •